Step-by-step instructions for gluing inner corners

After finishing, the main problem can be uneven walls and the resulting springs on the background. It’s also vital to take into consideration that as soon as the walls are crookedthe joints of background canvases may diverge.

After gluing the last one in the front of the inner corner of the cloth should measure the remaining distance. It is measured from the border of the glued cloth to the adjoining wall, and the resulting amount is added 10-15 millimeters. If the walls are extremely curved, then the additional figure may be more.

Cut a strip equal to the resultant figure, taking into consideration the allowance. The surfaces have been treated with adhesive. Depending on the sort of coat it might be only the wall or both surfaces.

The strip is then glued independently using the cut side into the wallsocket. The background should go on the other airplane.

In case the glued background is wrinkled, you have to make a few smallish cuts perpendicular to the springs.

Level or incline on the adjacent wall is a perpendicular lineup. The distance in the corner is equal to the width of the former cut strip, never adding additions.

The surfaces have been smeared with adhesive, and then the coating is glued into the wall with the flat side to the line. The cut side goes onto the adjacent wall.

Protruding corner should be pasted by analogy with the interior, however there are little gaps, which also need to be taken into consideration when working.

Measured the space remaining from the glued background to the adjacent wall. Add 20-25 millimeters to the obtained figure.

A section is cut away, taking into account the additional 20-25 millimeters.

Before gluing, the surfaces have been treated with glue.

The edge has to be glued into the wallpaper already fixed onto the wall, the own cut facet»extends» to the next plane. If necessary, small cuts are created in the place of going to another wallpaper, smoothed and pressed into the wallsocket.

Draw a vertical strip on the adjacent wall at a distance of only glued cut strip plus 6-10 millimeters.

After applying the adhesive, the strip is put on the wall with its flat side into the line, moving over the border of the already glued strip.

The joints are smeared with adhesive and ironed using a rollercoaster. Following that, the upper layer is cut along the gidpola.ru ruler and the 2 layers are combined together.